Bbk-performance 2523 Manuel d'utilisateur télécharger pdf

INS139

2005-up S197

Mustang Rear Control Arms

Part # 2523

Tools required- 18mm socket, 21mm deep socket, 50mm Torx bit, ratchet, long extension.

Pliers or vice grips.

UPPER ARM

STEP 1

Lift rear of vehicle and support axle on jack stands.

STEP 2

From inside the car, remove rear seat by pushing in on tabs under

seat front, one on each side. Lift seat bottom up and remove from car.

STEP 3

Remove the single 18mm bolt on center of trans tunnel.

STEP 4

Place a jack under one side of the fuel tank to support the weight of

the tank only. DO NOT LIFT THE VEHICLE BY THE FUEL TANK!

STEP 5

From under the car, remove the (2) #50 Torx bolts that retain the gas

tank straps. Let fuel tank hang down onto driveshaft.

STEP 6

Remove two 18mm bolts that retain upper control arm bracket to floor.

Lower the tank slowly. Tank will rest on the driveshaft when lowered.

NOTE The bolt that attaches the upper control arm to the rear end

housing has an arm/flag on one side to keep it from spinning. Be

sure to put your wrench or socket on the 21mm nut that is on the

other side to remove the bolt.

STEP 7

Remove the bolt that holds the upper arm to top of rear end housing.

STEP 8

Remove the bracket and arm from the vehicle.

STEP 9

Remove the 18mm bolt that holds the control arm to the bracket.

STEP 10

Install the BBK upper arm into the bracket using the original bolt and

tighten to 129 ft-lbs.

STEP 11

Install the bracket and arm back into the car and tighten the 2 bolts

that hold the bracket to the floor pan to 89 ft-lbs.

STEP 12

Tighten the BBK arm to the rear end housing using the original nut

and bolt to 129 ft-lbs.

STEP 13

Torque the front bracket bolt (inside the car) to129 ft-lbs. Reinstall

rear seat.

STEP 14

Lift fuel tank back into position and re-secure tank straps with the

original bolts.

LOWER ARMS

STEP 1

Jack up car and support axle on stands. Remove & install arms one

side at a time

NOTE

Release the parking brake before moving to STEP 2.

STEP 2

Remove clip for e-brake cable at caliper. Remove cable from

actuating arm. Slide cable out and thru lower control arm. Let the

cable hang.

1 2

Résumé du contenu

Page 1 - Part # 2523

INS139 2005-up S197 Mustang Rear Control Arms Part # 2523 Tools required- 18mm socket, 21mm deep socket, 50mm Torx bit, ratchet, long extension. Pli

Page 2

INS139 STEP 3 Remove front and rear 18mm control arm mounting bolts and remove control arm from the car. STEP 4 Install new lower arm with stock bolt

Commentaires sur ces manuels

Pas de commentaire

Bbk-performance 2523 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Bbk-performance 2523. BBK Performance 2523 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Bbk-performance 2523