Bbk-performance 16150 Manuel d'utilisateur télécharger pdf

4.6 Tuned Length Headers

Part #1615 – 16150

INS-088

INSTALLATION INSTRUCTIONS

www.BBKPERFORMANCE.com

IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).

BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).

Passenger-Side

Unbolt and remove starter from bell housing.

Remove motor mount from block if needed.

Remove stock exhaust manifold and gasket.

Install BBK header and supplied gasket.

Insert supplied collector studs.

Reinstall motor mount and starter.

Lower engine into chassis and tighten nuts.

Reinstall H-pipe using supplied washers, lock

washers and nuts at collector.

Lower car and reinstall intake hose and strut tower

brace (if applicable).

Re-connect negative (–) battery terminal.

Driver-Side

Disconnect EGR by-pass tube from top of exhaust

manifold.

Remove bolt from steering shaft at steering rack, move

shaft aside.

Although not necessary you may find more working

space by removing the motor mounts from the engine

block.

Remove stock exhaust manifold and gasket.

NOTE: On

some vehicles it may be easier to access the upper

exhaust manifold bolts from above the engine.

Install BBK header and supplied gasket.

These headers

have slotted mounting holes which will allow you to

start some of the header bolts before placement.

NOTE: On some applications it may be easier to

re-use some of the original stud type header bolts.

Insert one collector bolt down through each of the

slotted holes in the collector flange.

Reinstall motor mount and reassemble steering shaft.

CAUTION

Working under a car is hazardous. Use sturdy jack stands on a solid level surface.

Always wear protective eye wear.

Included in this kit: Headers, gaskets, header bolts, collector bolts, collector studs, washers, and nuts.

Tools required: Jack, stands, 5/16”, 1/2”, 9/16”, 1-1/16” open end wrenches. 5/16”, 1/2”, 9/16”, 18mm, 21mm sockets.

Step 1

Disconnect the (–) negative battery terminal, remove intake hose and air filter box, and remove strut tower brace

(if applicable).

Step 2

Lift vehicle as high as possible with jack and support with stands.

Step 3

Unplug all oxygen sensors (removal from H-pipe is not necessary).

Step 4

Unbolt H-pipe from manifolds and catback system and remove.

Step 5

Remove motor mount to K member nuts.

Step 6

Carefully jack up engine (we recommend using a solid block of wood to place under the engine) until mounts rise

out of K member.

NOTE: Watch for any hang-ups such as wiring harnesses or hoses while lifting engine.

Safely support in this position.

Résumé du contenu

Page 1 - Part #1615 – 16150

4.6 Tuned Length HeadersPart #1615 – 16150INS-088INSTALLATION INSTRUCTIONSwww.BBKPERFORMANCE.comIMPORTANT—All appropriate safety equipment (e.i., glov

Modèles reliés 1615

Commentaires sur ces manuels

Pas de commentaire

Bbk-performance 16150 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Bbk-performance 16150. BBK Performance 16150 User Manual [en] [es] [fr] Manuel d'utilisatio

Résumé du contenu

Modèles reliés 1615

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Bbk-performance 16150