Bbk-performance 15575 Manuel d'utilisateur télécharger pdf

1986-1993 Ford Mustang 5.0

Cold Air Induction Systems

Part #s 1556 & 1557

Step 1

Remove entire stock air inlet system from vehicle, this is easily done by removing the

hose clamp at the throttle body, the two mass-air mounting bracket bolts from the strut

tower/inner fender well area, and the two filter box mounting nuts at the top edge of the

factory air box.

Step 2

Once this entire assembly is removed from the engine bay, the air box silencer (if not

previously removed) will be exposed. This is located inside the inner fender well

directly behind the air filter housing and is attached with three nuts which once

removed will allow the silencer to be dropped down to the bottom of the fender and

removed from under the vehicle. Also remove the two rubber air box mounts from the

fender well by simply turning counter clockwise and unthreading.

Step 3

Remove the mass-air sensor from the main assembly by simply unclamping it from the

stock inlet hoses. Once disassembled you can now remove the three bolts attaching

the bracket to the bottom side of the mass-air sensor. This bracket and the related

bolts will not be utilized in the installation of the BBK Cold Air Induction System.

Step 4

To finish installation simply install components in the vehicle as shown in Figure 1. For

Fender well-style kits install components as shown in Figure 2.

Step 5

Some models come with a large black grommet. Install as shown in diagram then

lightly oil the inside diameter to allow the 3-1/2” filter tube to slide through the grommet.

1986-1993 Ford Mustang 5.0 Cold Air Induction Systems Part #s 1556 & 1557 Step 1 Remove entire stock air inlet system from vehicle, this is

Modèles reliés 1557 | 1556 |

Pas de commentaire